|
|
#8
01-31-2009, 05:09 PM
|
||||
|
||||
Floor Pan Brace/Seat Track Mount Repair
Finally repaired my floor pan brace/seat track mount. Had a buddy weld the original seat mount stud to a 2" x 4" x 1/8" piece of steel. I wanted to mount it inside the floor pan brace, but was unable to due to verticle pieces of sheet metal inside there. I bolted it in place as you see, but would like to weld it in place some day.
Along with the problem of the front seat mount being broken, the same side rear seat track foot was cracked almost completely through! So I was doing the "gansta lean" while driving. Had that welded up too. Little by little I'm getting the broken things fixed.
__________________
Toshi '93 SSP '90 LX 'vert - Sold '87 LX hatch (parted out) '88 LX 'vert (should have never) '83 GL hatch (college car, long gone) 
|
|
|
Threaded Mode