Just for extra protection, I went ahead and preped and treated the most prone areas with POR 15 for the added protection against future rust. Now for the other side, then I'll re-seam seal at factory locations. Once that's done I'll coat the entire bottom with the PPG wet on wet gray sealer and then my olive color will be applied. Finally I'll blow the GSP Fleet blue over onto the bottom to match my factory before pics. Soooo tempting to just paint the blue and clear it LOL...

GSP
 

Great progress....

Got both sides (from frame rails outward) coated with POR15. Now I'm almost ready to spray the olive sealer...

Olive sealer is on...

Decided I would replace the lower section of the core support as I already had a new lower half left over from another project. It really wasn't that bad but why not as I'm in too deep to cut corners LOL...

Cleaned up and coated inside with POR15 and sprayed edges with weld thru primer...

Nice! I wish the underside of my 85 SMPV looked that good! :)

It will one day Bill:2thumbs:

I broke out the Pro Spot and replaced the outer skin of the lower core support today...

I got a little excited and forgot to take pics but the bottom is done. Overspray replicated and entire bottom side satin cleared for protection. She's now off the rotisserie jail... I have a 8.8 temporarily in under her to move around. The 7.5 will be restored before it is put back in. Now it's at least Mobil so when it's ready I can move it into the paint both...

I GUESS we will forgive you for not taking photos of the finished underside! ;) I cannot wait to see this one finished. It will be quite a unique car (even around other GSPs).