|
Special Service Mustang Tech Any and all technical questions for SSP cars. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
How do you disassemble seat track?
I picked up a full set of seat tracks today. Both driver and passenger seat tracks. They have a bit of rust on them, but otherwise look good. I would like to disassemble them so that I may take care of the rust and then repaint them. How do you disassemble the seat track? I'm looking in between where the top meets the bottom, I see the rollers and in front of each roller is a, for lack of a better word, clip or retainer. I think that I need to get that retainer out of the way to slide the track apart. But how do I go about doing that?
__________________
Toshi '93 SSP '90 LX 'vert - Sold '87 LX hatch (parted out) '88 LX 'vert (should have never) '83 GL hatch (college car, long gone) |
#2
|
||||
|
||||
tracks
i dont think they separate, pretty sure they are spot welded together, if they are not too rusty, just soak em good with some liquid wrench and then degrease them for fresh paint, either way, no one can see them when the seats are in the car
__________________
Mike Jakubec 1990 WSP Commercial Enforcement Mustang 927WSP http://public.fotki.com/WSP-LXMike/ |
#3
|
||||
|
||||
Quote:
But that little retainer, one on each end is sitting in there loosly, so I thought that one could be removed and then I could slide the whole thing apart. Oh well. Like you said, you can't see them under the seats...
__________________
Toshi '93 SSP '90 LX 'vert - Sold '87 LX hatch (parted out) '88 LX 'vert (should have never) '83 GL hatch (college car, long gone) |
|
|